• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Figure 8656.0
Figure 8656.2

TM-5-3895-374-10 Paving Machine Bituminous Material: Crawler Mounted Diesel Engine Driven Manual
Page Navigation
  267    268    269    270    271  272  273    274    275    276    277  
TM 5-3895-374-10 options ..............utilities...............calibration ............ meters  .................................................................... AC Meter by Sample <8> <6> <5> <6> Calibration of the Asphalt Meter by weighed load Sample is one of the procedures that can not be run while making mix. On selecting this procedure the WARNING display shown in Figure 8656.e will be shown.  Note that even though this warning is displayed, the plant operation and data gathering continues uninterrupted. The Continuation Options are: OPTION KEY DESCRIPTION ESCape ESC Return  to  the  previous  display.    There  has  been  and  will  be  no interrupting of plant operation. (Access) .00 Interrupts  plant  operation.    Gain   access   to   the   asphalt   meter calibration procedure displayed in Figure 8656.1 The calibration display of Figure 8656.1 is a single form containing all the information necessary  to  calibrate  the  asphalt meter by weighed loads. The upper left portion of the display shows Test Parameters.  The desired rate at which the asphalt is recirculated and will be  pumped  is  specified  by  the  first  parameter  in  TPH.    The  density  of  the  sample  asphalt  is  specified  by  the  second parameter in lb/gal (at 600F).  The length of time the divert valve will be switched to the RUN, ie sample, position can be preset with the time interval parameter shown in seconds. The   Measured   Meter   Values   are   displayed   in   the   lower   left   portion   of   the   display.      These   are   the   display   of   the instantaneous pumping rate, the asphalt temperature, and the accumulated wet tons. The actual procedure is defined by the continuation options in the order shown. The Continuation Options are: OPTION KEY DESCRIPTION ESCape ESC Return to the previous display. Parameters 4 Enter Test Parameter data. Clear .00 Clear all totals. Start Test 7 Switch the divert valve to the RUN position. Correct Totals 8 Enter recalibration data. page F - 83 SYSTEMS Equipment Corp.  8/31/89  Page (44)







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.