• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Table E-1.  OPERATOR, CREW PREVENTIVE MAINTENANCE CHECKS AND SERVICE FOR MELTER, ASPHALT SKID MOUNTED HOT OIL CIRCULATING - Continued
APPENDIX F COMPONENTS OF END ITEM (COEI)

TM-5-3895-368-14P Hammer Pile Driver Self-Powered Diesel Manual
Page Navigation
  113    114    115    116    117  118  119    120    121  
TM 5-3895-368-14&P Table E-2.  ORGANIZATIONAL PREVENTIVE MAINTENANCE CHECKS AND SERVICES FOR MELTER, ASPHALT SKID MOUNTED HOT OIL CIRCULATING Location LOCATION ITEM ITEM TO NOT FULLY MISSION NO. INTERVAL CHECK/ PROCEDURE CAPABLE IF: SERVICE 1. Fluid Lines, Fittings and Monthly Valves a.  Visually inspect for leaks, breaks, loose mountings and connections. b.  Check valves for operation. 2. De-Drumming Tunnel Doors Monthly Visually inspect for damage and proper operation of doors. 3. Heating Coils Monthly Open de-drumming tunnel doors and visually inspect the coils for damage. 4. Melter Tank Monthly Visually inspect tank for leaks. 5. Melter Tank Cleaning Monthly Notify Direct Support Maintenance to clean tank as required IAW instructions in paragraph 4-1. 6. Electric Chain Hoist Yearly a.  Inspect all external parts for loose screws, bolts or nuts. b.  Inspect lift wheel and hook block for bright shiny area appearing on wear surfaces. c.  Check electrical cords and cables for damaged insulation. d.  Inspect trolley trackwheels for external wear on tread and flange. Replace worn trackwheels that show a flat wear area greater than 1/4 inch across or trackwheels that no longer rotate freely. e.  Adjust armature brake for 0.020-0.030 inch gap. E-3  (E-4 Blank)







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.